Kenwood “Sugar Cube” Style Rear CameraKenwood’s CMOS-210 rear-view camera is an excellent safety accessory to add to your Kenwood or Kenwood Excelon video receiver. This camera gives you a bright, wide 130-degree horizontal by 101-degree vertical view of what’s behind your vehicle when you’re backing up.
The camera renders a detailed 310,000 pixel resolution color image, and its highly sensitive CMOS sensor helps to eliminate distortion caused by nearby light sources like headlights. Mount the camera on your vehicle’s rear bumper or license plate, route the wire through your car to your video receiver, and you’ll never back over a garbage can again. The 29-foot long cable and harness assembly fits in most vehicles and includes a composite video connector, so it’ll work with almost any video receiver.
| General Features | |
| Camera Unit | |
| - Output Video | Wide-Angle Mirror Image (Rearview) |
| - Sensor | 1/4 inch color CMOS sensor |
| - Angle of View – Horizontal | Approx. 130°C |
| - Angle of View – Vertical | Approx. 101°C |
| - Color Signal System | NTSC |
| - Illumination Range | |
| Specifications | |
| Power | |
| - Operating Voltage | 14.4V (9.0 – 16 V allowable) |
| - Current Consumption | Approx. 60mA |
| - Grounding System | Negative Ground Type |
| General | |
| - Operational Temp Range | -30°C – +70°C |
| - Dimensions – Camera Unit | 24mm (W) x 24mm (H) x 24.9mm (D) |
| - Dimensions – Power Cord | 7.5M (24.6ft) |
This very versatile backup camera mounts literally anywhere.
150° color CMOS camera of dimensions 23.4(w) x 23.4(h) x 28.8(l) mm.
Specs: Pixels: NTSC 720(H)*486(V)
Sensor: 1/4″ CMOS Color Sensor
Sync. System: Internal
Resolution: 300 TVL
Minimum illumination: 20 IRE / 2 LUX
S/N ratio: More than 43dB
Gamma correction: 0.45
Gain control: AGC
Video output: 1.0Vp-p composite video. 75(OHM) load
Operation temp: -20°C TO 70°C
Operational humidity: Within85% RH
Supply voltage: DC12V (+/-5%) , 80mA(Max)
Water Proof: IP 68
View Angle: D150° H136° V115°.
Included:
NOT Included:
Included:
NOT Included: Molded polycarbonate body makes for a very clean look and built-in mounting tabs allow for flexible mounting and ease of installation. ONLY FOR USE WITH ROSEN NAVIGATION UNITS